christmas light repair tool
The LightKeeper Pro Quick Fix Trigger sends a shaped, electrical pulse through the defective bulb, clearing the shunt. This allows it to operate properly. The current can then flow through the light set completing the circuit and illuminating the other bulbs.
What is a shunt fixer for Christmas lights?
A shunt is any device that allows current to continue flowing through a circuit by creating a path of lower resistance than the original path. In incandescent holiday lights, shunts are small wires wrapped beneath the filament. Initially, they are coated with a substance that makes them an insulator.
Does the LightKeeper Pro work?
The LightKeeper Pro can fix about 95% of all light sets. One of the light sets that a LightKeeper Pro cannot fix are those with blackened bulbs.
How do I use LightKeeper?
Simply plug your LightKeeper Pro into the light set and pull the trigger. The LightKeeper Pro sends a pulse through the light set, finds the bad bulb, and fixes the shunt—allowing the light set to work properly.
What causes a section of Christmas lights to go out?
If only half the strand is out
If half a strand is working and the other half is not, you probably have a loose or broken bulb. Start with the first unlit bulb and work your way down, wiggling them to check for looseness. If it flickers, that’s your cue to replace it.
How do you fix a broken strand of Christmas lights?
How to Fix a String of Christmas Lights
Diagnose the problem. Carefully inspect each string of lights before plugging it into an electrical outlet. Find the bad bulb, and swap it out. Fix the faulty filament or shunt. Replace the fried fuse. Upgrade your lights.
How do you know which bulb is out on Christmas lights?
You can tell which bulb is out on your string of traditional Christmas lights by looking for the bulb that is “burned out” by looking at the tiny little filaments in the light bulbs to see which bulb is “burned out” or has lost it’s filament. Many times the bulb will be “smoked” as well.
How does shunt repair work?
To help drain the extra CSF from your brain, a VP shunt will be placed into your head. The VP shunt works by taking the fluid out of your brain and moving it into your abdomen (belly), where it’s absorbed by your body. This lowers the pressure and swelling in your brain.
Will LightKeeper Pro work on LED lights?
No, the LED Keeper uses a different technology specifically developed to perform on LEDs. Fortunately, the LightKeeper Pro is able to fix incandescent holiday lights and has the required technology for these sets.
How do you use a LightKeeper Pro bulb tester?
The Bulb Tester is designed to fit most miniature light bulbs. Place the bulb in the tester making sure the two thin wires of the bulb firmly touch the metal inside the bulb tester. A good bulb will illuminate when its wires touch the contacts of the Bulb Tester.
How do you find a short in Christmas lights?
Simply bring the light tester close to each bulb. The tester’s indicator will light up when it’s near a functioning bulb. If you have a non-contact voltage detector, bring the detector close to the wire section between each bulb to test for voltage. The dead section of wire will be the section after your bad bulb.
How do you fix outdoor string lights?
String lights often have fuses tucked inside the male plug end. To check the fuse, plug the broken lights into an electrical outlet that you know has power. Then, take a working string of lights and plug it into the broken set. If the lights on the second strand don’t light up either, the fuse is likely the issue.
Why are only half of my LED strip lights working?
Solution: You may chose to get a larger power supply that can handle the total wattage required, so a power supply higher that the total wattage of all your LED strips. Or you could get another power supply of the same size as you already have, and split the strips across 2 power supplies.
