cobra knot

Uses: The Cobra Knot (Solomon Bar or Portuguese Sinnet) (ABOK # 2496, p 401.) is one of the commonest lanyard knots. It is very widely used in military shoulder lanyards and in many macrame patterns. Application: When completed as shown in the animation, it provides an excellent lanyard pull for a snap shackle.

Is cobra knot same as square knot?

The process is similar to tying a square knot, but with a small difference because you’re working around a center strand. The width of your cobra stitch project will change based on the thickness of the cording you use for both the center and the knotting cords.

How do you finish cobra weave?

Bury Your Ends

Assuming you’re making a cobra bracelet, tie the last few knots a little bit loose. Then, on the back side, tuck the ends underneath those last few knots. Pull everything tight and trim down the ends. The ends should stay put, as the weave cords are not the ones holding the bracelet together.

How much paracord do I need for cobra weave?

The general rule for the cobra weave, and many other weaves, is: “One inch of bracelet equals one foot of paracord.” This is a generally accurate rule, unless you have very large wrists, you are making a wide bracelet, or you are using smaller diameter cord.