fireplace gas key
Fire Pit Valve Keys
Available sizes: 3″, 8″, 12″, 18″, 24″. Choose a key at least 1″ longer than distance from finish material to valve.
Why does my gas fireplace have a key?
It’s usually located near the fireplace, usually to the immediate left, right or on the floor. You will control the gas flow with a fireplace key (sometimes called a hex key) as you light the fireplace. Place a long lighter next to the burner and pull the fuel trigger.
How do you turn on a gas fireplace without the key?
It’s quite easy to turn a fireplace on without its key. Simply remove the key valve flange by turning it using your hand or any other tool. Next, light a piece of paper and put it in the middle of your fireplace where the pilot light is located. Lastly, gently turn on the gas using a little wrench.
Are all fireplace keys the same size?
Whether you’ve misplaced your key or just prefer an update, we have 3, 8, 12, 18, and 24-inch sizes available.
How do you turn off a gas fireplace valve?
All you have to do is open the front of your fireplace, turn the Pilot knob to “off,” and then turn your gas shutoff valve to the “off” position as well. So stay cool, stay frugal, and stay tuned here at Fireside Home Solutions for all your fireplace needs.
Should I turn off gas fireplace with key?
You should close or turn off the emergency gas valve. For those with a key valve, just insert the fireplace key into the slot and turn it until the valve closes. This cuts off the gas supply, and the pilot will go out.
Is it OK to leave pilot light on gas fireplace?
Generally speaking, it is safe to leave your continuous pilot light on at all times, assuming it stays lit (more on this in a moment). While it does cost more to keep your pilot light on in between uses, it can actually have some benefits to your system.
Can you manually light a gas fireplace with electronic ignition?
Re-lighting pilot lights is straightforward on today’s modern gas fireplaces. If you have an electronic ignition unit, using your remote control simply press the ‘on’ button and the pilot will re-ignite within a few seconds, followed by the fireplace a few seconds after that.
How do you manually light a gas fireplace?
Use these instructions to light a gas fireplace with a key.
Step 1: Review Owner’s Manual. Read through the included manual thoroughly before starting up the gas fireplace. Step 2: Remove Front Panel. Step 3: Insert Key into Gas Valve. Step 4: Light The Burner And Turn Key Counterclockwise. Step 4: Replace Front Cover.
Do all gas fireplaces have a pilot light?
It is important to remember that not all gas fireplaces have “standing” pilot light, or, a pilot light that is “always on”. The best way to determine if you have this type of gas fireplace is to look at the control knob of the fireplace. On a fireplace you will normally find the control knob behind the grate or door.
What is the wall switch for on a gas fireplace?
The wall switch sends an electrical signal to your fireplace to open a valve and release the gas for the pilot light to light it. Without power most fireplace valves will not open.
Do gas fireplaces have a flue?
The Gas Fireplace Flue
Among the other components of a gas fireplace (or gas logs), the flue is a chimney, pipe, or ductwork that allows gasses such as carbon monoxide to escape without losing fireplace heat. A flue damper is located inside of the flue.
