how to start stihl chainsaw
Starting
Step 1 of 15: Before starting your chain saw, the chain brake should be activated by pushing it forward (see picture).Step 2 of 15: Always remove the bar cover before starting your chain saw.Step 3 of 15: If your chain saw is fitted with a decompression valve, press it now.
Why can’t I start my Stihl chainsaw?
The carburetor might be clogged. A clogged carburetor is often caused by leaving fuel in the chainsaw for a long period of time. Over time, some of the ingredients in the fuel will evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and prevent the engine from starting.
Why are Stihl so hard to start?
Regular maintenance will help to ensure that your Stihl chain saw will always start. In addition, some storage steps can help with starting when the chainsaw has been left for an extended period. Problems starting a Stihl chain saw can be related to gasoline storage, spark plugs, and incorrect starting procedures.
How do I start my Stihl chainsaw after sitting?
Just let the saw sit for 30 min and the excess gas will evaporate. Remove the spark plug, dry it, crank over the engine a few times to dry the cylinder. Now refit the plug and try again. Set the switch to “On”, set throttle to fully open, set choke to “Off” and crank over the engine.
How does Stihl easy start?
A spring housing with the spring and two drive lugs is fitted between the rope rotor and the crankshaft. The force used to pull the starter rope tensions the spring against the opposing force created by the piston during compression.
How do you start a chainsaw that won’t start?
The chainsaw’s engine is flooded with fuel.
A common indication the engine has been flooded is the smell of gasoline in the air. If you believe fuel has flooded the chainsaw engine, pull the starter cord several times while holding the throttle, dry and replace the spark plug, and then try starting the chainsaw again.
How do you start a chainsaw?
Place the chainsaw on flat, level ground. Make sure the bar is clear of obstacles and bystanders are at a safe distance. Engage the chain brake. Engage the safety switch and simultaneously pull the trigger switch to start the chainsaw motor.
What CC is a Stihl 036?
The engine moves at speeds up to 13,500 rpm when in operation, and the idle speed is 2,500 rpm. The engine displacement is 3.75 cubic inches., and this refers to the total volume the pistons can move through the cylinder.
Where is the choke on a Stihl chainsaw?
The choke position is the fourth setting on the master control lever. This setting is used to start the saw when its motor is cold. Stihl chainsaws denote the choke position using a nearly horizontal squiggle between two vertical lines at the lowest position on the master control lever.
How many cc is a Stihl 038?
Re: stihl 038 038av 038 av super specs
038AV introduced in 1980 with 61cc.
